Santa Fe Roof Pros provides professional fascia & soffit in Santa Fe, NM for residential and commercial properties across northern New Mexico. Half our fascia calls come from houses that do not have any. A pueblo-revival elevation has a parapet, a coping and a row of projecting viga ends. The job people are describing is entirely real, but the components have different names and they fail in different ways.
Viga ends are the version that matters most. Those peeled logs project a foot or more past the wall face, they take full sun and every drop of roof runoff, and the grain end is wide open to weather. Rot starts at the exposed end and travels back into the pocket where the beam bears on the wall, which is the point at which the repair stops being cosmetic and starts being structural.
We treat them in three tiers. A sound viga gets cleaned, cut back to solid wood if the end has checked, and sealed with a penetrating oil rather than a film finish that traps moisture behind it. A partly failed one gets the projecting section scarfed and replaced. A viga rotted back into its pocket needs that pocket opened, and that is carpentry and masonry working together.
Canale surrounds are the other frequent failure and they rarely get mentioned. The trim boards framing a wooden canale sit directly in the discharge path, so they go first. If the pan lining below them was short or absent, they have been soaking from beneath as well as from above, and replacing the visible board without correcting the pan simply repeats the whole cycle.
On the pitched stock the conventional work is genuinely conventional. Rotted fascia comes off, the rafter tails behind it get inspected and sistered wherever they have gone soft, new fascia goes on primed on all six faces, and the drip edge is set so it actually directs water into the gutter rather than behind it and down the wall. Vented soffit panel goes back only where the attic bays behind it are genuinely open.
Portals get their own treatment. The posts, corbels and latillas on a traditional porch are exposed structural timber carrying a roof, and they are usually the oldest wood anywhere on the property. We will tell you plainly when a portal has become a restoration job rather than a roofing job, because carpenters who do that work well are worth waiting for. We will happily coordinate the roof around their schedule rather than the other way round.
Our licensed and insured team brings the right materials and equipment to every job — canale pans lapped six inches inside the parapet, continuous parapet coping wrapped down both faces, sprayed polyurethane foam with a silicone topcoat, 60 and 80 mil TPO and PVC single-ply membrane, torch-applied two-ply SBS cap sheet, tapered polyisocyanurate cut to a quarter inch per foot — and backs the work with a written workmanship warranty. We serve Santa Fe and nearby communities including Eldorado at Santa Fe, La Cienega, Agua Fria, Pojoaque.
What We Handle
Everything our fascia & soffit in Santa Fe covers
One crew, one point of contact, and the full range of fascia & soffit work in Santa Fe, NM. If it is on this list we do it in house rather than handing it to a subcontractor:
- fascia repair santa fe
- soffit repair santa fe nm
- fascia replacement santa fe county
- viga end repair santa fe
- rotted fascia board santa fe
- portal beam repair
- santa fe fascia contractor
- wood trim roof repair santa fe
- latilla repair
- canale wood repair
- parapet trim repair
Not sure which one describes your situation? Describe it in plain words and we will sort it out — or browse the rest of our Santa Fe services.
Materials, equipment and how we do fascia & soffit
The difference between fascia & soffit that lasts and fascia & soffit that gets redone in three years is almost always preparation and materials, not the finish you see on day one. We work with canale pans lapped six inches inside the parapet, continuous parapet coping wrapped down both faces, sprayed polyurethane foam with a silicone topcoat, 60 and 80 mil TPO and PVC single-ply membrane, spec them to the job instead of to the invoice, and write the material grades into the free estimate so you know exactly what you are buying.
Every Santa Fe job runs the same way: site walk and measurements, written scope and fixed price, protection of the surrounding area, then the work itself with a daily clean-up. Years of roofing work in northern New Mexico means we have already met whatever your property is going to throw at us — awkward access, older construction, an HOA with opinions.
Where we do fascia & soffit outside Santa Fe
Santa Fe Roof Pros covers Santa Fe and the surrounding communities of northern New Mexico. Crews run out to the same nearby cities every week, so an out-of-town job does not mean an out-of-town price.
- Fascia & Soffit in Eldorado at Santa Fe, NM — Santa Fe County, population 6,005
- Fascia & Soffit in La Cienega, NM — Santa Fe County, population 3,885
- Fascia & Soffit in Agua Fria, NM — Santa Fe County, population 2,913
- Fascia & Soffit in Pojoaque, NM — Santa Fe County, population 2,071
- Fascia & Soffit in Nambé, NM — Santa Fe County, population 1,907
- Fascia & Soffit in Tano Road, NM — Santa Fe County, population 1,573
Start on the Santa Fe Roof Pros homepage for a free estimate, or call (844) 511-2320 and describe the job.
Why Santa Fe Chooses Santa Fe Roof Pros
- ✓We test drainage with a hose and a clock against the state's half-inch, 48-hour standard before we quote anything.
- ✓Every canale is rebuilt with a metal pan lining running six inches inside the parapet, not patched with sealant.
- ✓Parapet caps are held with cleats at the vertical faces because the code forbids fasteners across the horizontal top.
- ✓We price pumice removal openly, because New Mexico no longer permits granular fill to stay in a roof assembly.
The standards behind fascia & soffit
Quality here is not a matter of opinion — it is written down. The fascia & soffit work we do in Santa Fe follows published industry standards: NRCA publishes the Roofing Manual, the industry's reference for details and slope minimums, and Asphalt Roofing Manufacturers Association sets the shingle application and ventilation guidance the warranties reference. If a contractor cannot tell you which standard a detail comes from, that is worth asking about before you sign.
Every fascia & soffit project in Santa Fe gets the same attention, whether it is a single room or a full commercial job. We show up on schedule, keep the site clean, and stand behind the work — the estimate is free and there is no pressure.
Ready to get started? Call (844) 511-2320 for a free fascia & soffit free estimate in Santa Fe, or request a quote and we'll get right back to you.